Jump to content
Click here if you are having website access problems ×

Paul Richards

Area Representative
 View Profile  See their activity

  • Posts

    3,735

  • Joined

  • Last visited

  • Days Won

    8

 Content Type 

Everything posted by Paul Richards

  1. Paul Richards
    Have now found some. Thanks.
  2. Paul Richards
    Try Bigg Red or BCS
  3. Paul Richards
    Planning to arrive with ESV around 5.00pm on Friday. Help with setting up would be appreciated.
  4. Paul Richards
    Bottom bolt holding shocker to de dion is 1/2 inch UNF. Be careful it's all too easy to cross thread (you may already have done so by the sound of things. To line things up it sometimes helps to turn the shocker through 180 degrees as rubbers tend to stick in a not quite straight position - if you see what I mean. To ensure bolt goes in straight it's sometimes better to remove the top link of the de dion so that de dion can be twisted to help line up bolt exactly.
  5. Paul Richards
    I have a brand new (still in bags) pair of anodised stanchions. £50.
  6. Paul Richards
    Best to mount "terminals to the bottom" where possible Good idea.
  7. Paul Richards
    Unfortunately relays are often poorly made and prone to ingress of water. I'm not sure that any are better than another. My first went a bit faulty after about 9 years, so not a big problem at only £5 each. I did think about taking one apart and trying to seal it better using glue but then it was easier just to buy a new one to carry as a spare.
  8. Paul Richards
    Like these I need 2 x 6 inch and 2 x 8 inch.
  9. Paul Richards
    Me too.
  10. Paul Richards
    Tom I think it is in midst of being updated.
  11. Paul Richards
    Just on our way home from a couple of days with Peter and Lin Williams. Returned their re-bag after German trip and managed to meet up with some of the N. Wales crew at Rhos on Sea on Sunday. A pleasant weekend. By the way, Chris Proudlove has the L7C banner for Audlem on Sunday and will pass to Bill Blundell who will bring to Tatton for you.
  12. Paul Richards
    May be interested in a set if burnside isn't.
  13. Paul Richards
    ??R500 is fuel injected and doesn't have a carburettor.
  14. Paul Richards
    "Which engine ? On the K series it's on the front of the block - close to where the oil filter screws into." I think you are confusing with oil pressure sender. Normally temperature sender is in Apollo tank. Not sure of location on dry sump.
  15. Paul Richards
    Check the amount of grease in front wheel bearings. Most newish cars I've seen have very little/inadequate grease which could lead to early failure.
  16. Paul Richards
    I think I may have some new ones in my garage. I'll have a look tomorrow.
  17. Paul Richards
    My engine is a similar spec to yours and I run a Radtec with standard fan.
  18. Paul Richards
    I have some magazines on the ESV. Not sure if there is an April edition, but will check in 2 weeks when I next see ESV at Silverstone.
  19. Paul Richards

    Brake switch

    Paul Richards replied to Rex's topic in TechTalk

    Brake light switches are poor quality and often fail. A better quality one is available from Car Builder Solutions.
  20. Paul Richards
    It wasn't me, but I was in Freiburg in the 7 just over a week ago (along with a few of the LADS).
  21. Paul Richards
    Just ring Redline.
  22. Paul Richards
    Correct.
  23. Paul Richards
    JV has it right. Check for leaks on exhaust manifold.
  24. Paul Richards
    Send it to Oxted. They turned mine around in a couple of days.
  25. Paul Richards
    Test sig
×
×
  • Create New...