throttle linkage bolt

[pie_boy69]

Where can I get the bolt that holds a set of twin throttle cables to the linkage, this is the bolt type thing with 2 holes for the cables to pass through then 4 nuts to nip up the cables which pass either side off the actuating arm.

I can't see any in demon thievs anyone now of specialist carb shops?

Cheers Keith

 

[oilyhands]

You can easily make one from a bolt with a plain shank, an M6 one is ideal, you just cut the head off the bolt and tap the plain end down until the plain shank is the correct length to fit in the centre of the actuating lever, then drill two small (2.5mm) holes to accept the cables, four M6 nuts and washers later and you have a perfect anchor shaft for the cables.

 

Oily