Dry sump installation - K-series

[Shaun_E]

I am struggling to assemble the bits for my newly purchased dry sump kit.

Some bits appear to be missing but the real problem is that I have no concept of what it's supposed to look like. Please could someone post some pictures or point me in the right direction. I would like to see how the scavenge pump/cradle assembly goes together, what the connections to the sump pan look like and a general view of the bell housing with all it's connections.

So far I think I am missing "O" rings for the oil sleeve and an oil hose adaptor for the oil pickup/gauze assembly. Also I think that there should be "O" rings on the gauze union that screws into the bottom of the dry sump tank.

Thanks,

Shaun

 

Edited to remove the rant now that I have calmed down a bit 😳

 

Yellow SL #32

 

Edited by - Shaun_E on 20 Nov 2004 14:24:50

[Jason Plato]

As I suggested last week ask caterham for assembly instructions and check the inventry against the parts before you leave the counter .

 

Then take a look at R300.net and in the build section is some good photos of the parts you mention.

 

 

[Shaun_E]

Dave - I have the instructions and they are OK except for no pictures. I'll have a look on R300.net as that's really all I want is to see what the finished assemblies looked like.

I appreciate the advice to check everything at the counter but I had a huge box of bits and not enough time to check it all ☹️.

 

Yellow SL #32