Big Brake Upgrade shims?

[Rich.E]

I'm fitting my big brake upgrade and found that I need to use shims on the LH side between the upright  and caliper to centre the caliper on the disk, I suspect the disk is too far inboard? and that the bearing spacer shim maybe wrong? there is one fitted but I don't know if it's correct or do I need two?

it works just fine, but bothers me that it's not the same both sides

 

Thanks

[7 wonders of the world]

Shims are for that purpose to correct slight variations in manufacturers tolerances in hubs steering arms calipers etc.

The most important thing is to get the caliper as central over and parallel to the disc as possible.

You can buy shims down to 0.1mm online to if needed