Immobiliser

[Ian Lummis]

Good evening I would like to remove the centre tunnel cover from my r400 the only problem is the immobiliser warning lamp is attached to it is there a multi plug underneath the dash somewhere thanks. 

[Jonathan Kay]

Which type of R400, and what's the year?

Ordinary or Stack dash?

Have you already got the appropriate wiring diagram?

Thanks

Jonathan

[Ian Lummis]

The car is a S3 2010 redg  ordinary dash. 

[Ian Lummis]

No I haven't got a wiring diagram. 

[ScottR400D]

When you lift the tunnel there's quite a bit of free cable to the immobiliser light and it has a small single push in connector somewhere along it. Just disconnect it and remove the tunnel  

When my car had some warranty work carried out it was sent back with the warning light inoperative because CC had nipped the cable between the chassis and tunnel cover. They sent me a new cable which was a.doddle to change.   

I'm sure if you lift the tunnel it will be clear. 

[Jonathan Kay]

The wiring diagram is at the back of the Assembly Guide that I sent.

: - )

Jonathan

[Ian Lummis]

Thanks for reply will have a look tomorrow. 

[Ian Lummis]

Thanks for your help.

[ScottR400D]

I should have said, they sent me a new LED connected to a length of cable with a connector on the end. 
I lifted the tunnel, disconnected the old LED and it's damaged bit of cable, pulled it out of the tunnel and threaded through and reconnected the new one.