Drilling the 3 holes for a new Momo steering wheel

[David_Stamp]

I am thinking about getting a new Momo steering wheel to replace the current one - does anyone have a quick, foolproof way to accurately drilling the three mounting holes? All advice welcome!

[Jonathan Kay]

Previous discussion.

I can't find a template.

Jonathan

[David_Stamp]

Thank you Jonathan

[Guy Lowe]

When I bought mine the supplier drilled it, countersunk it and supplied the black anodised bolts & nylons at n extra cost. 

[Doc007]

Make sure you drill them the right way up! I bought a secondhand wheel without thinking and when it arrived the hole pattern is the opposite to my other wheels (and therefore the steering column.

I'm going to have to get an adapter plate made up to switch them around as the MOMO logo is in the position of one of the holes if I were just to drill three more. Anyone know where/who could make the be up for me?

[ScottR400D]

#5 I don't remember too clearly but not long after building my car in 2015 I needed another QR fitting because my son and I wanted different steering wheels. (Being different heights, with the original I couldn't see the shift lights, with mine he can't see the speedo!)

I just bought a standard Lifeline boss and found that with it on the wheel drilled as per the original CC supplied one, the wheel was upside down!

The conclusion I drew was that the bosses supplied by CC are 180 degrees out to the standard Lifeline bosses. In the end I had to buy a new upper column c/w boss from CC. 

You might find that your S/H wheel will fit with a non CC Lifeline boss.