Mrb00ns Posted May 1, 2022 Share Posted May 1, 2022 Hi,I'm tinkering with my Caterham today and noticed that a lot of the base studs for poppers on the bodywork are pop riveted in place rather than screwed. I can't get my rivet tool flush against the stud. Is there a specific bit of kit I need? I'm using a manual riveter, don't have enough need for an air riveter. Thanks in advance!Chris Link to comment Share on other sites More sharing options...
Beagler Posted May 1, 2022 Share Posted May 1, 2022 Photo of area would be good Link to comment Share on other sites More sharing options...
OldAndrewE Posted May 1, 2022 Share Posted May 1, 2022 I think all mine were riveted. All I have done is get a short length (5 mm or so) of aluminium rod of a suitable diameter, drill a hole through it, and put that over the nail of the rivet effectively making an extended nose to the rivet gun. The bases normally use countersunk rivets Link to comment Share on other sites More sharing options...
Area Representative Paul Richards Posted May 1, 2022 Area Representative Share Posted May 1, 2022 If I understand you correctly the nose of the riveter interferes with the popper. A common problem. Easiest way is to place a v small nut (one that will go into the popper) over the "shaft" of the pop rivet. Link to comment Share on other sites More sharing options...
ScottR400D Posted May 1, 2022 Share Posted May 1, 2022 Is the problem that the nose of the riveter is too big to go fully into the popper?You maybe just need an extension nozzle for your riveter. Search on 'pop rivet extension nozzle'.Or you can put a few small washers or a small nut on the back of the rivet to enable the rivet itself to be pushed down into the popper. You get them back when the mandrel breaks, of course. Edit: Beaten to it! As said, a common problem. Link to comment Share on other sites More sharing options...
Wrightpayne Posted May 1, 2022 Share Posted May 1, 2022 Like Scott400D I use a few small washer to get the 'nozzle' spaced outside of the popper. Try and get some the same size or smaller than the rivet head. I used one a fraction bigger and it wedged itself inside the popper and was a challenge to get out.I've recently found a small bush that works so I only have to find one thing when the rivet pops rather that several! Small nut is a great idea too!! (I do like a bit of lateral thinking / problem solving!) Link to comment Share on other sites More sharing options...
Mrb00ns Posted May 1, 2022 Author Share Posted May 1, 2022 Gentlemen, your knowledge and practicality is greatly appreciated. Problem solved! Link to comment Share on other sites More sharing options...
Tony Whitley Posted May 1, 2022 Share Posted May 1, 2022 I have a Stanley pop riveter which is good for getting into awkward spaces but also the nose is small enough to fit into a popper base. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now