Dixa1225 Posted February 13, 2022 Share Posted February 13, 2022 Just fitting the new CC LED rear lights. The fixings holes for the number plate light are different. Do most people just re drill additional holes & seal up the old bracket holes?Thanks Link to comment Share on other sites More sharing options...
Leadership Team SLR No.77 Posted February 13, 2022 Leadership Team Share Posted February 13, 2022 I did that, but I think if I was doing the job again I'd try to use the existing chassis holes and drill appropriate holes in the bracket. It's completely bonkers that the holes don't match.Stu. Link to comment Share on other sites More sharing options...
ScottR400D Posted February 13, 2022 Share Posted February 13, 2022 Another double post!! Link to comment Share on other sites More sharing options...
ScottR400D Posted February 13, 2022 Share Posted February 13, 2022 I felt the worst thing about the kit was the idea of drilling all the extra holes in that chassis rail, for the loom and the bracket. I ran the loom over the top of the fuel tank where it is held by cable ties on adhesive bases and I used the centre hole on the bracket and added a couple of pieces of 3M VHB double sided at each end. So no extra holes.Another thing I did was remove the connectors from the main lights and run a 34mm grommet onto the wires, refit the connector and now the hole in the wing behind the light is filled in. I bought blind grommets and punched 6mm holes in them. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now