TomB Posted April 24, 2019 Share Posted April 24, 2019 My internal side panels have been loosened at the top around the cockpit opening to allow for respraying and new external panels. Now they look a bit battered with a soft crease where they have been manhandled. Any suggestions on how I can flatten these out a bit prior to fitting? Or do I simply rivet them back on and any crease/ deformities will work out? Also, the panels have been pushed around the edge of the carbon dash, and unless I rebend them, Im going to struggled to get them back under the dash. Am I best filing a bit off the dash, or filing a slight dip in the ali panel, or something else? When I was at Arch, Bruce flattened the edge of the shoulder panels with a metal hand tool that looked like a vertical section had been taken through a domestic iron, with a handle at the top and a flat edge at the base for flattening out the metal. Link to comment Share on other sites More sharing options...
Jim 123 Posted April 24, 2019 Share Posted April 24, 2019 If you get some bar section ((say 40mm dia) metal billet, could you roll out the creases without damaging the powder coat? The top edges of the inner skin may benefit from a roll of J section profile rubber strip to trim the top edge with the long section of the J against the outermost face. Link to comment Share on other sites More sharing options...
TomB Posted April 24, 2019 Author Share Posted April 24, 2019 Thanks Jim. Your idea of essentially using a heavy rolling pin to roll out the creases sounds worth a try. We have a ~30-40mm diameter marble rolling pin in the kitchen..... Link to comment Share on other sites More sharing options...
Mark w Posted April 24, 2019 Share Posted April 24, 2019 Ahh the good old rolling pin .Reminds me of when i managed to remove a small dent from the side of my bonnet with the wifes rolling pin on the kitchen table .She happened to be out at the time *rofl* Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now