blueyedbiker Posted May 9, 2018 Share Posted May 9, 2018 Next up is the underside of the dashboard where the radius is less than the required 19mm, current chassis’ have a correct radius here but mine doesn't. The obvious solution here would be to have a padded trim piece made up to match the tunnel top but other solutions are most welcome.Ta, yet again. Link to comment Share on other sites More sharing options...
Jim 123 Posted May 9, 2018 Share Posted May 9, 2018 A length of hose or pipe insulation cut longitudinally and slid over the dash underside for presentation to the IVA. Might need some glue on the rear surface. Link to comment Share on other sites More sharing options...
elie boone Posted May 10, 2018 Share Posted May 10, 2018 If i am correct it should not have rivets ether, the only "clean" solution would be a change of dash with the correct radius. Link to comment Share on other sites More sharing options...
blueyedbiker Posted May 10, 2018 Author Share Posted May 10, 2018 Thanks for the responses, I'll have a chat with my local trimmer and see if he can make up a padded strip to match the tunnel cover. Link to comment Share on other sites More sharing options...
Jim 123 Posted May 10, 2018 Share Posted May 10, 2018 PM sent. Link to comment Share on other sites More sharing options...
blueyedbiker Posted May 10, 2018 Author Share Posted May 10, 2018 Ta Jim, replied. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now