1646958 Posted April 28, 2017 Share Posted April 28, 2017 Hi Guys,Anybody got experience on fitting a steering assembly,two halves refuse to slide together, lower column under stress from sliding through pedal box. hence top and bottom half out of alignment. Derek at Caterham has no explanation so stuck. Link to comment Share on other sites More sharing options...
MADMALC Posted April 28, 2017 Share Posted April 28, 2017 Have you connected the lower part to the rack? If you have try loosening the rack and rotating to change the angle. Or disconnect the lower part from the rack and connect the two parts first then adjust the rack to the natural line. Link to comment Share on other sites More sharing options...
SM25T Posted April 28, 2017 Share Posted April 28, 2017 Slide bottom end of lower column off the splines of the rack. Fit the two halves of the column togther with some of the top part poking into the cockpit ... then push forwards and fit UJ to splines on rack Link to comment Share on other sites More sharing options...
ChrisC Posted April 28, 2017 Share Posted April 28, 2017 Assume if your talking to Derek is a new build, so all new parts. It may be to late for my first comment, but here goes anyway, If you have a removable steering wheel, and intend for Caterham to do the IVA, don't bother with the top steering column bush. It will be removed and refitted during the process, so save the effort. When you do put it in, make sure the plastic insert is the correct way round. If its incorrect it will push into the column tube as you fit the upper column. Don't connect the lower column to the UJ until you have the upper and lower columns in place (not clamped), in fact don't have the UJ on the rack either for that extra bit of space. Lube the columns inside on upper and outside on lower, and wiggle them as they slide. My S3 had a little unused fixing hole and tang that just touched the lower column (in the pedal box), it was spotted during IVA and a simple bend of the unused fixing point solved the problem, but maybe this is causing your alignment problem? Finally you could always remove the grommets from the cheese wedge to get that bit more wiggle room, but they may be a cow to refit. Link to comment Share on other sites More sharing options...
1646958 Posted April 29, 2017 Author Share Posted April 29, 2017 Many thanks Chris, I had already removed the bottom universal joint , if I slide the lower searing shaft in it does hit that lower lug and it is hard against the top of the exit hole into the engine bay. I will nock the lower tag up out of the way and see if that helps.Thanks again John Q Link to comment Share on other sites More sharing options...
Jim 123 Posted April 29, 2017 Share Posted April 29, 2017 Have you left the steering rack clamp bolts loose for now? I recall that these don't get tightened until the column assembly is lined up and in place. Keep an eye out for clearance between the column where it passes under the belt tensioner. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now