glasgow Posted May 19, 2016 Share Posted May 19, 2016 I bought this light http://www.carbuildersolutions.com/uk/rectangular-high-intensity-led-rain-light-65mm-x-106mm.I cut off the two bolts at the rear of the light and will attach the light directly on the metal boss that originally used to hold the spare wheel. See this pic from the internet Any suggestion for strong fast acting glue to use to attach the light to the metal boss please? Link to comment Share on other sites More sharing options...
Wrightpayne Posted May 19, 2016 Share Posted May 19, 2016 If its to wire up as a third brake light I think its too low - most put on the roll bar Link to comment Share on other sites More sharing options...
glasgow Posted May 19, 2016 Author Share Posted May 19, 2016 I do have a roll bar light but it is not seen well if the half hood is on. I saw the above light in David Blue Aberdeen CSR and looked amazing. I am still keeping my roll bar one though. So in reality it is a 4th light-hope this is legal to have 4 brake lights In hindsight i should have just kept the two bolts and drilled the boot but it is too late now Link to comment Share on other sites More sharing options...
Roger Ford Posted May 19, 2016 Share Posted May 19, 2016 Beware that most LED rain lights are quite directional. If you mount it "flat" on the back panel it's going to pointing upwards quite a lot. Given how low it is, that might make sense, but check that it still works OK at a distance.As for legality, the MOT tester's manual says: Vehicles first used on or after 1 January 1971 must be fitted with two obligatory stop lamps. Additional stop lamps fitted and connected must be tested. Where extra lamps are fitted and there is doubt as to whether they are connected, the benefit of this doubt should be given to the presenter.Now that only means it'll pass an MOT, not that it's (necessarily) compliant with all Construction and Use regulations, but I reckon you're pretty safe. Link to comment Share on other sites More sharing options...
revilla Posted May 19, 2016 Share Posted May 19, 2016 Isn't there also a height limit, below which lights red lights are to be regarded as fog lamps and above which they are additional brake lights? Link to comment Share on other sites More sharing options...
glasgow Posted May 19, 2016 Author Share Posted May 19, 2016 Thank you.Now back to the main issue please. Which glue: I am thinking of Loctite 435 but only available in 20gm and seem too expensive for such a job. any other suggestions please Link to comment Share on other sites More sharing options...
Member Jonathan Kay Posted May 19, 2016 Member Share Posted May 19, 2016 Is there space in the case to take the head of a bolt which would go through the back and screw into the boss?If there isn't I'd make a plastic spacer out of something, probably by cutting a box down. Bolt though that to the boss and glue it to the case using either Araldite Rapid or cyanoacrylate.Jonathan Link to comment Share on other sites More sharing options...
ECR Posted May 21, 2016 Share Posted May 21, 2016 I'd look at number plate double sided tape first ..... Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now