Englishmaninwales Posted October 27, 2015 Share Posted October 27, 2015 Done this plenty of times for K series, but not for a Sigma engine. Any special advice or specific difficulties to be aware about before I tackle this job, S3 metric chassis. (job is to investigate an oil leak, expecting to replace a leaking crank seal and also to fit a LW flywheel).ThanksMalcolm Link to comment Share on other sites More sharing options...
SM25T Posted October 27, 2015 Share Posted October 27, 2015 Label everything you disconnect. Link to comment Share on other sites More sharing options...
Jonathan Kay Posted October 27, 2015 Share Posted October 27, 2015 A few Sigma-specific hints in this thread.Jonathan Link to comment Share on other sites More sharing options...
Englishmaninwales Posted October 27, 2015 Author Share Posted October 27, 2015 Thanks for that link, Jonathan. Looks like the belt tensioner needs to come off and to expect a battle with the fuel connector. Link to comment Share on other sites More sharing options...
ChrisC Posted October 27, 2015 Share Posted October 27, 2015 Fuel connector is a simple, you can do it with you fingers, just push the clip. The tensioner has to come off. I removed the alternator as well but I guess you dont need to do that. The tensioner can only be pulled off the studs when its clear of the column, so don't forget to put it back on the studs as you lower it back in. There are engine manuals online, which I found to be a great help getting the flywheel bolt settings correct. Link to comment Share on other sites More sharing options...
Simon.Rogers Posted October 27, 2015 Share Posted October 27, 2015 Hi MalcolmI did this on the SV recently to replace the clutch slave. Like you I could do the K or Busa blindfolded and upsidedown but at certain times on the SV Sigm I thought why the bloody hell do I need to do that!!!!Eg had to remove the steering column to allow No1 primary to come out from under the column. All due to a stud in the head not a bolt!!!!! AAGGHHHH!My friendly Sigma Hotline at PGM even got to the what do you bloody want now :-oIn the end its a liitle longer but realistically not to different just that you need to do some different things.Cam belt tensioner needs to come off for instance. Call me if you wish! Link to comment Share on other sites More sharing options...
DJ. Posted October 27, 2015 Share Posted October 27, 2015 I did this earlier this year.Removing the auxillary belt tensioner and alternator makes it easier, but I didn't remove the steering column. Removing and refitting the primaries is possible on an S3, but does look tricky.Duncan Link to comment Share on other sites More sharing options...
Simon.Rogers Posted October 28, 2015 Share Posted October 28, 2015 Yes Andy and I were comparing things S3 to SV. So steering column is under primary 4 on the S3 but over on the SV and its the last stud in the head that stops it coming out. If that was a bolt it would be OK. Conversely the belt tensioner comes off with the engine still in place on the SV. So you don't need to lift first and remember to slot it back on before lowering. Link to comment Share on other sites More sharing options...
Englishmaninwales Posted October 28, 2015 Author Share Posted October 28, 2015 Thanks for all the info! Very useful. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now