ScoobyJ Posted October 5, 2014 Share Posted October 5, 2014 Hi i have a tacho which has a 12 pin connector at the back, can anyone assist me in identifing the tachometer output wire from the ECU, i am trying to fit a shift light and need to identify the wire to grab a feed. thanks Link to comment Share on other sites More sharing options...
oilyhands Posted October 5, 2014 Share Posted October 5, 2014 Which engine/ECU?Oily Link to comment Share on other sites More sharing options...
ScoobyJ Posted October 5, 2014 Author Share Posted October 5, 2014 HiCosworth Duratec 2.3 with a standard MBE ECUJ Link to comment Share on other sites More sharing options...
oilyhands Posted October 6, 2014 Share Posted October 6, 2014 Pin 34 on the MBE 967 series.Oily Link to comment Share on other sites More sharing options...
ScoobyJ Posted October 6, 2014 Author Share Posted October 6, 2014 Thanks I will give it a shot Link to comment Share on other sites More sharing options...
ChrisC Posted October 6, 2014 Share Posted October 6, 2014 I tapped into my tach wire at the point where the engine loom connected to the main loom. There was a four wire ecoseal connector, so I just created a little connecting lead with a male and female ecoseal connectors and patched into that. This way there is cut into the original loom, and the engine can still be removed with the loom attached. Link to comment Share on other sites More sharing options...
ScoobyJ Posted October 11, 2014 Author Share Posted October 11, 2014 Thanks for the advise Chris, i will check it out, how did you identify the wire? Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now