Jump to content
Click here if you are having website access problems ×

Omex Shift lights - connection issues


Wile7

Recommended Posts

Hi chaps,

 

Purchased these shift lights a few years ago (new) and finally got round to installing them this morning *redface*.

 

My problem is that when I connect to the coil using the spare spade connectors the car does not start.... *confused* Disconnect the coil and things are fine.

 

I've used a scotch block to connect into an earth - could that be an issue?

 

Any advice welcome please *smile*

 

Dave

Link to comment
Share on other sites

  • Member

My first guess is that it's taking the voltage at the coil terminal to earth. But that can't be a fault in the earth from the module. It could be anywhere else, including inside the module.

 

1 Check connections are as intended. (Again!)

 

2 Can you check the positive from the coil outside and inside the module and see if it's shorting to earth?

 

Are the instructions available?

 

Jonathan

Link to comment
Share on other sites

  • Member

Quoting Jonathan Kay: 
My first guess is that it's taking the voltage at the coil terminal to earth. But that can't be a fault in the earth from the module.
This might not be true, by analogy with that strange fault with brake lights where a bad earth causes an unusual earth route to occur.

 

I'd put that Scotchlok back on the list of possible problems.

 

Jonathan

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...