Tiff Posted December 17, 2002 Share Posted December 17, 2002 I'm at the stage on my R300 build of assembling the Watts link. The manual is far from clear. On the shorter rear arms it is not possible to thread the rod ends right in due to the contriction of the waisted section of the arm. This means that when the arms are horizontal the bell crank is not vertical. Should it be? Link to comment Share on other sites More sharing options...
Fred Posted December 17, 2002 Share Posted December 17, 2002 Have you set up the measurement if so turn it back half a turn.then tighten up the lock nut. LOOK here Edited by - fred on 17 Dec 2002 12:38:08 Link to comment Share on other sites More sharing options...
Tiff Posted December 18, 2002 Author Share Posted December 18, 2002 Thanks Fred. In my case the build manual should have an introduction that says "First put on your reading glasses" !! Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now