jackb_ms Posted January 24, 2014 Share Posted January 24, 2014 Hello all Does someone has a spare clutch cable bush which I could borough or take dimensions for me? I would need the outside diameter of the cylindrical part, the height of the cylindrical part, the outside diameter of the "washer" part and the diameter of the hole going through. I need to make a bespoke one for my car and I need to order some nylon bush which I will then modify. Cheers Jack Link to comment Share on other sites More sharing options...
Grim Reaper Posted January 25, 2014 Share Posted January 25, 2014 I just happen to have my engine in bits in the garage so can do this for you quite easily.. Overall length 28.5mm Outside diameter of cylinder 12.5mm Inside diameter of cylinder 10mm Outside diameter of 'washer' 22mm 'Washer' thickness 3mm which makes the cylinder 25.5mm long Link to comment Share on other sites More sharing options...
jackb_ms Posted January 25, 2014 Author Share Posted January 25, 2014 Thank you 😬 You're a star Jack Link to comment Share on other sites More sharing options...
Grim Reaper Posted January 25, 2014 Share Posted January 25, 2014 Make a couple because I'll probably have lost mine by the time I get it back together again. Link to comment Share on other sites More sharing options...
jackb_ms Posted January 27, 2014 Author Share Posted January 27, 2014 I was going to order a few nylon bushes 50mm high with an outside diameter of 22mm and inside diameter of 10.4mm. Then it is a question of machine them down to size. Jack Link to comment Share on other sites More sharing options...
elie boone Posted January 27, 2014 Share Posted January 27, 2014 Is it this one ? Link to comment Share on other sites More sharing options...
Grim Reaper Posted January 27, 2014 Share Posted January 27, 2014 See, I've lost it already! Link to comment Share on other sites More sharing options...
Grim Reaper Posted January 27, 2014 Share Posted January 27, 2014 I was going to order a few nylon bushes 50mm high with an outside diameter of 22mm and inside diameter of 10.4mm 10.4mm ID would leave a lot of slack, the thread is M10 and the nipple is almost exactly 10mm wide. Wall thickness would be getting a bit thin too unless you're planning on making the hole on the block bigger. Link to comment Share on other sites More sharing options...
jackb_ms Posted January 27, 2014 Author Share Posted January 27, 2014 I've changed my mind... I'm going with nylon rod so could drill at 9.8 which i think the correct hole size for m10 Jack Link to comment Share on other sites More sharing options...
Grim Reaper Posted January 27, 2014 Share Posted January 27, 2014 The hole is 10mm to allow the nipple to go straight through, it will not go through an M10 nut (I tried) the threaded part of the cable just sits within the bush, adjustment is via two nuts on the cable already, I don't think they will come off over the nipple (knowing that I can't get an M10 nut over it from the other direction) Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now