Support Team Shaun_E Posted February 25, 2013 Support Team Share Posted February 25, 2013 Is there a boss for the exhaust mounting bracket on the drivers side? If not what's the best route to fitting the bracket? Thanks, Shaun Link to comment Share on other sites More sharing options...
Pendennis Posted February 25, 2013 Share Posted February 25, 2013 Shaun, I drilled straight through the right hand bottom seat belt mount. Long bolt from inside to out with nyloc on outside. Link to comment Share on other sites More sharing options...
ruff seven Posted February 25, 2013 Share Posted February 25, 2013 Thats the way to do it. Link to comment Share on other sites More sharing options...
Jason Plato Posted February 25, 2013 Share Posted February 25, 2013 its a horrid job with a tiny drill bit after you have measured the other side of the chassis to gauge where the hole should be . Or you can remove the inner side skin and go at it from that side outwards if you know what I mean Link to comment Share on other sites More sharing options...
Support Team Shaun_E Posted February 25, 2013 Author Support Team Share Posted February 25, 2013 Thanks folks. Link to comment Share on other sites More sharing options...
ruff seven Posted February 25, 2013 Share Posted February 25, 2013 I have done this a few times, i have always ground a point on a long bolt and wound it in so it gives a witness mark, then remove and drill from outside. Link to comment Share on other sites More sharing options...
Support Team Shaun_E Posted February 25, 2013 Author Support Team Share Posted February 25, 2013 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now