Luke QR 4 Point harness

[alicat]

Are the harness's left and right handed?

 

Is it possible to change which part of the harness is captive in the catch?

 

If not I suspect I have two right hand harness's 🤔 🤔

 

 

[STEVE GILBERT]

Carefully remove the centre Luke Sticker to undo the catch screw, undo the backplate screws, re-arange the pins and straps, re-assemble, then I used thin carpet tape to refix the luke sticker without any sign it had ever been removed.

Disclamer: This is not recommended, this may comprimise safety,do at own risk, etc bla bla bla

Hope that helps

Steve.

 

See My Zetec Power 7 Here

[alicat]

many thanks!

 

I suspected it could be done.

 

 

[Fred]

now thats good will this mean you can change the pasenger one with the lock meck

so you can fit to tunnel like the drivers side

 

fred

[STEVE GILBERT]

Yep Fred, thats right so off you go and get your tools 😬

 

See My Zetec Power 7 Here

[Fred]

thank you i'am on my way don't want my new paint job getting clobbered with that thing

when i have a pasenger getting out. 😬

 

fred

[alicat]

Looks like i've started something here.

 

The whole reason for asking was exactly the same as everyone else is complaining about, the clip bashing the side skin when the passenger gets out.

 

 

[Pierre Gillet]

The buckles are sometime a litlle difficult to undo. I mean it is sometimes hard to extract the metal ends of the straps from the bucle itself.

Is there anything that can be done without compromising safety?

[Pierre Gillet]

The buckles are sometimes a litlle bit difficult to undo. I mean it is sometimes hard to extract the metal ends off the straps from the bucle itself.

Is there anything that can be done without compromising safety?

[Pierre Gillet]

The buckles are sometimes a litlle bit difficult to undo. I mean it is sometimes hard to extract the metal ends off the straps from the bucle itself.

Is there anything that can be done without compromising safety?

 

Pierre