Nigel Pugh Posted September 14, 2002 Share Posted September 14, 2002 Guys, Thanks for the help on my prop question last night. I thought I would come to the Sevens font of knowledge again with a question re my front wishbones. They are allready built now and complete on the car. But ( as usual !!) the manual contradicted its self re the spacing washers. The manual has a diagram showing the lower wishbones with two 1/2" washers either side, of both sides of the w/b. Then in the next section it tells you to change this for a widetrack to just 4 washers at the rear of the w/b. I know this is for a change in the suspension geometry, but is it OK? Also in doing this I can no longer squeeze in another washer next to the other side of the wishbone, is this also correct? Thanks again in advance. Nige. Nig Pug X400 SLR - R400 in bits!! Link to comment Share on other sites More sharing options...
scooby dooby doo Posted September 14, 2002 Share Posted September 14, 2002 i think its the usual build manual style. do it like this. aha! you have one of theoptions fitted. that means take it all to bits and do it like this! HOOPY R706KGU CYCLE WINGS AEROSCREEN K SERIES CUCUMBER Link to comment Share on other sites More sharing options...
Fred Posted September 14, 2002 Share Posted September 14, 2002 morning nigel hear you are here fred Link to comment Share on other sites More sharing options...
Nigel Pugh Posted September 14, 2002 Author Share Posted September 14, 2002 Morning Fred, Thanks for the advice and the pic. Thats the way I have it, so by pure luck its correct. Wait a mo, thats the whole caterham build philosophy is'nt it - hope and pray then a bit of luck? I notice you also have pwp from Blueyonder. I have set mine up here too but need to get around to posting the pics so far. May be later. I off into the garage now to start on the prop/axle and rear suspension. Im sure I may have more questions later tho. Thanks. Nige. Nig Pug X400 SLR - R400 in bits!! Link to comment Share on other sites More sharing options...
Red SLR Posted September 14, 2002 Share Posted September 14, 2002 I did it using the 4 washers rather than 2 on each side. Simon. Have a look at my web site, think its on there somewhere. Simon. See X777CAT here Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now