bobt Posted November 20, 2009 Share Posted November 20, 2009 Is this one likely to be ok with Kseries/6speed/single plate setup ? here on ebay Link to comment Share on other sites More sharing options...
davidvoas73 Posted November 20, 2009 Share Posted November 20, 2009 Could be, alternatively you can align by eye (worked every time for me) or invest 50p in a 8" length of dowel with a diameter just less than the spigot bearing, insert into spigot bearing, mark position of clutch cover fingers on dowel, wrap masking tape round dowel at this point so that diameter of masking tape is a few mm greater in diameter than the internal diameter of the hole in the clutch cover plate. The masking tape will compress whenthe dowel is inserted allowing you to adjust position of frictionplate relative to the cover. (again worked very well for me) airborne tweaked supersport Link to comment Share on other sites More sharing options...
prs Posted November 20, 2009 Share Posted November 20, 2009 I've got that type and they are so easy to use, well worth it IMHO Link to comment Share on other sites More sharing options...
bobt Posted November 20, 2009 Author Share Posted November 20, 2009 Perfect, and purchased :-) Many thanks PS been using the dowel and tape method for years but getting fed up of loosing them :-) Link to comment Share on other sites More sharing options...
myothercarsa2cv Posted November 21, 2009 Share Posted November 21, 2009 I use a screw driver Just nip up the housing so you can still jiggle the plate about but it stays, IYSWIM, et voila. I have excellent eyesight though John _________________________ myothercarsa2cv Bugsy: '82 2cv6 😬 Talloulah '08 1.6K Classic Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now