millsn Posted April 5, 2008 Share Posted April 5, 2008 my wings aren't drilled. I don't really know where they should go fore/aft versus the mount. Does anyone have the bolted variety they could let me know how far along the curve of the front wing the bolt holes are? I.e. distance between leading edge of wing, following the profile of the wing to the hoile centres. Link to comment Share on other sites More sharing options...
7 wonders of the world Posted April 5, 2008 Share Posted April 5, 2008 Assuming these are 13" models then first check the stays are equal usually they need a little tweak, then sit them on and measure 51mm form the front edge to the front of the front stay - best to do this in the middle of the wing to avoid the curve, you can centralised the wings over the wheels by sight / checking the gap between the edge of the wing to the stay. Are you drilig or bonding them, the later being easy and if done properly very secure Too young to be old ! Link to comment Share on other sites More sharing options...
stevefoster Posted April 5, 2008 Share Posted April 5, 2008 I'd glass fibre em on - roughen the underside weave and give a couple of inches either side of the wing stay - on until you need to remove them then. Bolts are fine but clip anything and the wing will be off before you can shake a stick at it. I've seen too many "I lost my front wing thread" to consider anything else. Link to comment Share on other sites More sharing options...
millsn Posted April 5, 2008 Author Share Posted April 5, 2008 Gents, I have no wish to start another "how do you fix cycle wings on the car" thread. So I'll not be drawn. 😬Thank;s for the location info. Mr Foster, you should know better! Link to comment Share on other sites More sharing options...
stevefoster Posted April 6, 2008 Share Posted April 6, 2008 The older I get the less 'better' I know 😬 Link to comment Share on other sites More sharing options...
Alaskossie Posted April 6, 2008 Share Posted April 6, 2008 Does anyone know the proper distance from the front of the cycle wing to the leading edge of the wing stay, for the 15-inch wheel? Any difference from the measurement for a 13-inch wheel? TIA. Alaskossie Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now