Drumster Posted May 7, 2007 Share Posted May 7, 2007 Just removed the knee trim panel on the driver's side and on replacing it I noticed I have a loose/unattached brown wire. Should this be loose? Engine starts up fine. The brown wire is the one that is connected to the resistor, one wire from the resistor is connected to position 1 on the master switch and the remaining brown wire from the resistor is the one that is unconnected. If it should be connected, what do I connect it to? Any advice greatly appreciated. Chris Alston C7CAT 1800 Supersprint Drive it like you stole it! but don't tell my pupils that 😳 Link to comment Share on other sites More sharing options...
Myles Posted May 7, 2007 Share Posted May 7, 2007 Details in the 7FAQ (link, top-right of the page...) here 🙆🏻 🙆🏻 🙆🏻 🙆🏻 🙆🏻 Alcester Racing 7s Equipe™ 🙆🏻 🙆🏻 🙆🏻 🙆🏻 🙆🏻 Alcester-Racing-Sevens.com Link to comment Share on other sites More sharing options...
Myles Posted May 7, 2007 Share Posted May 7, 2007 Broadly-speaking, it sounds like the loose wire should be connected to ground... 🙆🏻 🙆🏻 🙆🏻 🙆🏻 🙆🏻 Alcester Racing 7s Equipe™ 🙆🏻 🙆🏻 🙆🏻 🙆🏻 🙆🏻 Alcester-Racing-Sevens.com Link to comment Share on other sites More sharing options...
Drumster Posted May 7, 2007 Author Share Posted May 7, 2007 Doh! I never think to check 7FAQ Thanks Myles. 'Twas the ground that had gone astray. All sorted Chris Alston C7CAT 1800 Supersprint Drive it like you stole it! but don't tell my pupils that 😳 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now