allegro Posted February 12, 2002 Share Posted February 12, 2002 I am in the middle of adjusting the camber on the two fronts, but have a little problem. I have undone the bolt at the top wishbone attaching it to the front hub assembly, but I cannot get this bolt out to enable me to spin the top and so adjust the camber. Is there a trick to getting this bolt out question.gif Andy Mac teeth.gif Out of Control RED SLR teeth.gif Link to comment Share on other sites More sharing options...
Fred Posted February 12, 2002 Share Posted February 12, 2002 sorry andy its been a long day i was thinking of something else tbhall777 is a good way you can also hit it up with block of wood leave nut on a bit you dont want to damage th threads if you end up using a ball joint splitter you may tear the seal spray it first with a bit wd40 fredid=blue> smile.gif Edited by - fred on 12 Feb 2002 22:52:00 Link to comment Share on other sites More sharing options...
allegro Posted February 12, 2002 Author Share Posted February 12, 2002 Evening Fred It is not so easy to get in there with a hammer. I take it you mean give the threaded end of the bolt a good thump question.gif Should I undo the anti roll bar first question.gif And the other end so that the anti roll bar can turn freely. Andy Mac teeth.gif Out of Control RED SLR teeth.gif Link to comment Share on other sites More sharing options...
tbhall777 Posted February 12, 2002 Share Posted February 12, 2002 Get 2 x M14 fine pitch nuts, preferably 1 half nut. Screw on, lock together and then turn. Re-lube with copper-slip, when putting back. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now